RedMax CZT60+ Manuel D'utilisation page 4

9. Hour meter
10. Throttle control
11. PTO button
12. Seat adjustment lever
13. Deck lifting lever
14. Type plate
15. ROPS
Roll Over Protection Structure
(ROPS)
ROPS is a protective frame that decreases the risk
of injury if the product overturns. Use the ROPS and
the safety belt when you operate the product on
slopes.
Steering controls
The direction of the product is controlled by the 2
control levers. Refer to
The control levers can be moved forward and
rearward from a neutral position. Refer to
the product on page 13 .
Operator Presence Control (OPC)
The OPC engages when the operator lifts from the
seat. The engine and the drive to the blades stop if
the blades are engaged or the parking brake is not
Operation conditions on page 9 .
applied. Refer to
Ignition key
The ignition key has 4 positions:
• Start position (A)
• Run position (B)
• Headlight position (C)
• Stop position (D)
A
B
C
D
4
Product overview on page 3 .
To operate
Headlights
A
B
C
D
• Turn the ignition key to the headlight position (C)
to operate the product with the headlights on.
• Turn the ignition key to the run position (B) to
operate the product with the headlights off.
Throttle control
The throttle control adjusts the speed of the engine
and the speed of the blades if the blades are
engaged. The throttle control has 2 end positions,
idle speed and full throttle.
A A
• Full throttle (A) - increases the engine speed.
• Idle speed (B) - decreases the engine speed.
CAUTION:
engine at idle speed (B) for longer time
than necessary. Too much operation
time at idle speed can decrease the life
of the spark plugs.
Choke control
The choke control is used for cold starts to supply
more fuel to the engine. Pull up the choke control
when you start a cold engine.
Product overview on page 3 for the position
Refer to
of the choke control.
B
Do not operate the
1739 - 001 - 08.11.2021