Important Instructions; Unpacking And Installation - Nordcap FS60CP Mode D'emploi

Important Instructions:

The appliances mentioned in this document are only intended for preservation and cooling of
beverages in bottles and cans.
 Read the manual In order to obtain full benefit of the appliance.
 It is the user's responsibility to utilize the appliance according to the instructions.
 Contact the dealer immediately in case of any defects.
 The appliance is only for indoor use.
 The appliance should be placed in a dry sufficiently ventilated room.
 The appliance should not be placed near a source of heat or direct sunlight.
 The appliance should not be placed near a ventilation or air condition system.
 Note that all electrical appliances can cause danger.
 Do not store explosives such as gas, petrol, ether or similar substances in the appliance.
 Asbestos nor CFC have been used in the production of the appliance.
 The oil in the compressor does not contain PCB.
- THIS APPLIANCE MUST ALWAYS HAVE AN EARTHED PLUG!
- AT REPAIR ALWAYS UNPLUG THE APPLIANCE!
- ONLY FOR APPLIANCES WITH REFRIGERANT R290/R600a!
 This appliance contains a flammable refrigerant, so make sure of good ventilation around the
appliance.
 Do not use mechanical devices when defrosting, this can cause leakage of the cooling system.
 Do not use electrical appliances inside the refrigerated storage compartment.
 Any repair of the appliance should be carried out by a skilled technician (EN 60335-2-89: 2010).

Unpacking and Installation:

Remove the packing and check that the cabinet has no transport damage.
Any transport damages should be reported to the transport company and noted on the delivery note.
 When building-in ensure a distance of at least 50 cm behind the appliance and above the appliance.
 Make sure that the air intake at the bottom panel is not blocked.
 Place the appliance in a level position for correct functioning. This can be achieved by adjusting the
adjustable feet:
at
32