Troubleshooting - Kenwood KMM-BT728HD Mode D'emploi

References
(For /
Each time you press DISP, the display information changes.
• If the information is unavailable or not recorded, "NO TEXT", "NO INFO", or other information
(eg. station name) appears or display will be blank.
Source name Display information: Main display
STANDBY Source name/Clock
RADIO Source name/Clock
For FM Radio Broadcast Data System stations only:
Source name/Clock
Radio text+ Radio text+ song title/Radio text+ artist
Clock back to the beginning
USB For MP3/WMA/AAC/WAV/FLAC files:
Source name/Clock
File name Playing time
iPod USB/iPod BT When [MODE OFF] is selected (page 12):
Source name/Clock
Clock back to the beginning
PANDORA/ Source name/Clock
PANDORA BT Album title Playing time
SPOTIFY/ Source name/Clock
SPOTIFY BT Playing time Clock
BT AUDIO/ Source name/Clock
ALEXA Clock back to the beginning
AUX Source name/Clock
42
ENGLISH
)
Main display
Clock back to the beginning
Frequency Clock back to the beginning
Station name/Program type Radio text
Frequency
Song title/Artist Album title/Artist
Clock back to the beginning
Song title/Artist Album title/Artist
Station name Shared/Radio Title
Clock back to the beginning
Context title Song title Artist Album title
back to the beginning
Song title/Artist Album title/Artist
Clock back to the beginning

Troubleshooting

Symptom
Sound cannot be heard.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
Source cannot be selected.
• Sound cannot be heard.
• The unit does not turn on.
• Information shown on the
display is incorrect.
The unit does not work at all.
Correct characters are not
displayed.
Folder name
(For
Playing time
"SET ERROR"/"DEL ERROR"
Artist
• Radio reception is poor.
• Static noise while listening
to the radio.
Playback order is not as
Playing time
intended.
Elapsed playing time is not
correct.
Remedy
• Adjust the volume to the optimum level.
• Check the cords and connections.
Turn the power off, then check to be sure the terminals
of the speaker wires are insulated properly. Turn the
power on again.
Send the unit to the nearest service center.
Check the [SOURCE SELECT] setting. (Page 6)
Clean the connectors. (Page 39)
Reset the unit. (Page 4)
• This unit can only display uppercase letters, numbers,
and a limited number of symbols.
• Depending on the display language you have selected
(page 7), some characters may not be displayed
correctly.
Setting/deleting the remote control ID is unsuccessful.
)
Turn the power off, then turn on the power and perform
the operation again. (Page 7)
Connect the antenna firmly.
The playback order is determined by the order in which
file name were recorded (USB).
This depends on the recording process earlier (USB).