Makita CL183D Manuel D'instruction page 5

To remove the battery cartridge, slide it
from the tool while sliding the button on the
front of the cartridge.
To install the battery cartridge align the
tongue on the battery cartridge with the
groove in the housing and slip it into the
place. Insert it all the way until it locks in
place with a little click. If you can see the
red indicator on the upper side of the button,
it is not locked completely.
CAUTION:
Always install the battery cartridge fully
•
until the red indicator cannot be seen.
If not, it may accidentally fall out of the
tool, causing injury to you or someone
around you.
Do not install the battery cartridge
•
forcibly. If the cartridge does not slide in
easily, it is not being inserted correctly.
Battery protection system
The tool is equipped with a battery
protection system.
automatically cuts off power to the motor to
extend battery life.
The tool will automatically stop during
operation if the tool and/or battery are placed
under one of the following conditions:
Overloaded:
•
The tool is operated in a manner
that causes
abnormally high current.
In this situation, release the switch
trigger on the tool and stop the
application that caused the tool to
become overloaded. Then pull the
switch trigger again to restart.
If the tool does not start, the
battery is overheated. In this
situation, let the battery cool before
pulling the switch trigger again.
Low battery voltage:
•
The remaining battery capacity is
too low and the tool will not
operate. If you pull the switch
trigger, the motor runs again but
stops soon.
remove and recharge the battery.
This system
it to draw an
In this situation,
Switch action
CAUTION:
Before inserting the battery cartridge
•
into the tool, always check to see that
the switch trigger actuates properly and
returns to the "OFF" position when
released.
1
015496
To start the tool, simply pull the switch
trigger. Release the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched
•
off and the battery cartridge is removed
before carrying out any work on the
tool.
Disposing of Dust
CAUTION:
Empty the cleaner before it becomes
•
too full, or the suction force weakens.
Be sure to empty out the dust inside
•
the cleaner itself. Failure to do so may
cause the filter to be clogged or the
motor to be damaged.
015497
5
1. Switch trigger
1. Capsule
1