Lenze ECSEE 012 Instructions De Montage page 62

1 Safety instructions
General safety and application notes for Lenze power supply modules
Electrical connection
When working on live power supply modules, applicable national regulations
(e.g. VBG 4) must be observed.
The electrical installation must be carried out according to the appropriate
regulations (e.g. cable cross−sections, fuses, PE connection). Additional
information can be obtained from the documentation.
The documentation contains information about installation in compliance with
EMC (shielding, earthing, filters, and cables). These notes must also be observed
for CE−marked power supply modules. The manufacturer of the system is
responsible for compliance with the required limit values demanded by EMC
legislation. The power supply modules must be installed in housings (e.g.
control cabinets) to meet the limit values for radio interferences valid at the site
of installation. The housings must enable an EMC−compliant installation.
Observe in particular that e.g. the control cabinet doors should have a
circumferential metal connection to the housing. Reduce housing openings and
cutouts to a minimum.
Operation
If necessary, systems including power supply modules must be equipped with
additional monitoring and protection devices according the valid safety
regulations (e.g. law on technical equipment, regulations for the prevention of
accidents). The power supply modules can be adapted to your application.
Please observe the corresponding information given in the documentation.
After the power supply module has been disconnected from the supply voltage,
all live components and power terminals must not be touched immediately
because capacitors can still be charged. Please observe the corresponding
stickers on the power supply module.
All protection covers and doors must be shut during operation.
Note for UL approved systems with integrated controllers: UL warnings are
notes which only apply to UL systems. The documentation contains special
information UL notes.
Maintenance and servicing
The power supply modules do not require any maintenance if the prescribed
operating conditions are observed.
Waste disposal
Recycle metal and plastic materials. Ensure professional disposal of assembled
PCBs.
The product−specific safety and application notes given in these instructions
must be observed!
l
62
EDKCSEE040 DE/EN/FR 5.0