LaserLiner AutoCross-Laser ACL 4P RX Mode D'emploi page 12

AutoCross-Laser ACL 4P RX
Working with the laser receiver RX 50:
For levelling over longer distances or in conditions
of bright light, use the laser receiver RX 50.
Switch on with button D; control lamp A will light
up.
IMPORTANT: Set the ACL 4P RX to hand receiver
mode (button 13). The laser lines will now pulsate
with high frequency (10 kHz), making the laser
lines darker. The laser receiver can detect these
pulsating laser lines up to a maximum distance of
50 m.
Now move the receiver field (F) of the laser
receiver through the laser lines upwards and
downwards (horizontal laser line) and/or sideways
(vertical laser line) until the centre LED (G) lights
up. Now mark the horizontal and/or vertical
reference dimension.
Adjust the sensitivity of the laser receiver with
button B. Green LED (C) for close-range working
up to max. 15 m, red LED (C) for distance-range
working up to max. 50 m. The sound can be
switched on or off with button E.
Note:
The light intensity of the laser lines is highest in the middle and lessens
towards the edges. The maximum range of the laser receiver therefore also
changes accordingly: Green LED max. 7 – 15 m, red LED max. 30 – 50 m.
Universal mount:
The laser receiver RX 50 can be fitted on
measuring staffs with the universal mount. The
Flexi measuring staff (Art. No. 080.50) is always
recommended when measuring from floor
heights. It also allows you to determine heights
directly without any need for calculation.
12 ENGLISH
A
B
D
F
G
C
E