Disassembling - L-Acoustics ETR8-2 Manuel D'utilisation

XT
COAXIAL RANGE -
rigging procedures
VERSION 1.1
3. Select the desired enclosure's orientation (10° steps angle selection) and secure the locking pin to the enclosure
through the U-bracket's pivoting arm.
Figure 13: Selecting and securing the enclosure's orientation
!
The locking pin must be located on the pivoting arm (and not on the fixed arm) to secure the
U-bracket to the enclosure.
Verify that the enclosure is secured to the U-bracket by checking that the locking pin is engaged
and cannot move freely.
WARNING
L-ACOUSTICS recommends using an additional safety point when rigging enclosures.
!
A safety eye-bolt accessory can be added using the M8* insert located on the rear face of the
12XT enclosure (see Figure 19).
WARNING
* The "M8" notation refers to the European standard (see applicable external documentation).
6.2.2

Disassembling

Disassembling should be carried out in the reverse order of assembly.
XTP_RM_ML_1.1
P
SELF-POWERED COAXIAL RANGE
Select the
enclosure
angle in 10°
steps
w w w . l - a c o u s t i c s . c o m 16 en