Technical Data; Installation - Electrolux EUC25300W Notice D'utilisation

As much as the advice does not lead to result, call the nearest brand-mark service.
Replacing the lamp
1. Disconnect the appliance from the power
socket.
2. Replace the bulb with one of the same
power (the maximum power is shown on
the light diffuser) and with E14 socket
type.
3. Connect the plug to the mains socket.
4. Open the door. Make sure that the light
comes on.

Technical data

Dimension
Rising Time
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.

Installation

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
3. If necessary, replace the defective door
Height
Width
Depth
Climate
class
SN
N
ST
T
Location
To ensure best performance, if the appliance
is positioned below an overhanging wall unit,
stallation".
gaskets. Contact the Service Center.
1800 mm
595 mm
623 mm
34 h
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
electrolux 25