Electrolux EUC25300W Notice D'utilisation page 26

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

26 electrolux
the minimum distance between the top of the
cabinet and the wall unit must be at least 40
mm . Ideally, however, the appliance should
not be positioned below overhanging wall
units.
If the cabinet is placed in a corner and the
side with the hinges facing the wall, the dis-
tance between the wall and the cabinet must
be at least 10 mm to allow the door to open
enough so that the equipment can be re-
moved.
The ventilation space can be:
• directly above the appliance
• behind and above the top cupboard.
In this case, the space behind the top cup-
board must be at least 50 mm deep.
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility if
the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.
Removing the transport support
Your appliance is equipped with transport
support to secure the door during transpor-
tation.
To remove them do these steps:
1. Open the door.
2. Remove the transport support from the
door sides.
3. Remove the transport support from the
lower hinge (some models are fitted with
this).
Important! Some models are fitted with a
silencing pad under the cabinet. Do not
remove this pad.
50mm
Spacers
Install the spacers provided within the ac-
cessory bag as shown in the figures.
When two appliances are placed beside
each other, attach the adhesive spacers be-
tween the appliances.
3
2

Publicité

Table des Matières
loading

Table des Matières