Safety Instructions - Brew Monk TITAN Mode D'emploi

1. Safety Instructions

• Read all the instructions carefully and keep this manual for future reference.
• Do not use the device if the cord or plug is damaged; it should be replaced before use.
• The machine is intended for use only with 220-240 V and 50/60 Hz. Do not use an adaptor as
the wattage power of this device is high.
• Avoid overloading the electric supply.
• If the device requires extra power, do not use multi-outlets of under 13 A, and do not connect
any other device to this outlet.
• Check the product's rating label and make sure its voltage is fit for your outlet voltage before use.
• The device must only be used as intended. It must be operated safely and correctly under fault-
free conditions. Ensure to check the proper conditions prior to each use.
• The appliance is only to be installed in locations where it is supervised.
• DON'T LOCK THE LID DURING THE BOIL TO AVOID OVERPRESSURE.
2. Brewing Preparation
• The device must be positioned on a stable, secure and horizontal support structure prior to use.
• A full vessel contains boiling hot liquids and can weigh up to 70 kg (70 litres Brew Monk). A
horizontal positioning is a prerequisite for transfer pumping during the brewing process. Avoid
an unsteady surface.
• The device may not be moved during the brewing process. The handles are only meant for
transporting the device in an empty state.
• It is imperative to keep children and animals away from the device while it is in operation.
Remember boiling water is very dangerous.
• Always clean all the parts of your brewing equipment, hygiene is imperative to get good
brewing results.
• Before use, we recommend to heat up some water in the kettle to clean the brewing equipment
by using a proper cleaning agent (Chemipro Wash).
2.1 Circulation Pipe Assembly and Pump Information
• We advise not to run the pump without water. The boiler must be filled with water before
switching on the pump.
• We recommend using the pump during mashing process.
• Before switching on the pump, make sure to install the curved pipe (11). Assemble the
curved pipe (11) by placing it on top of the circulation pipe (2). Check that the seal ring
is installed and lock the curved pipe (11) in place by pressing down the two handles.
If you want to use the SST lid (5) during mashing, you will have to place the lid (5) before
assembling the curved pipe (11). The curved pipe (11) should first be inserted through
the hole in the lid (5).
• Adjust the flow rate using the blue valve on the circulation pipe for correct circulation speed.
If the pump speed is too fast, the malt pipe (8) will overflow down the central pipe, and the
bottom of the kettle may run dry and cause ingredients to burn and overheat the element.
Instruction Manual Brew Monk Titan - EN
23