Warm Tech FES2000-MIG2 Traduction Des Instructions D'origine page 20

Instructions for Use
· The appliance can be operated either by the
switches located on the top right hand
side of the fire or by supplied remote
control.
Manual Operation
· The switches located at the top right hand
side of the fire .The standby switch must be
first switch on..
· Press once the O/I button to turn on the
appliance and fire effect.. A red indicator
light will appear to indicate that the function
is ON. Press the O/I button for 3 seconds
this will operate the dimmer mode.
· Press once the 1000W button for the low heat
settings; press twice to switch off the heat
setting.
· Press once the 2000W button for the high
heat settings; press twice to switch off the
heat setting.
Remote Operation
· The standby switch located at the top right
hand side of the fire must be first switch on..
· It takes some time for the receiver to respond
to the transmitter. Do not PRESS the
buttons more than once within two seconds
for correct operation.
· Press once the button ON/OFF on the remote
control this turns ON/OFF the appliance
and fire effect.
· Press once the 1000W button for the low heat
settings; press twice to switch off the heat
setting.
· Press once the 2000W button for the high
heat settings; press twice to switch off the
heat setting.
· Press the DIMMER button for operate the
dimmer mode.
Safety Cut-Off
· This appliance is fitted with a safety cut-off
which will operate if the fire overheats (eg.
due to blocked air vents). For safety
reasons, the fire will NOT automatically reset.
· To reset the appliance, disconnect the
appliance from the mains supply for at least 15
minutes. Reconnect the supply to the
mains and switch on the appliance.
Troubleshooting
Symptom
No operation/ no fan.
No fire effect light.
Cleaning
· Warning-Always disconnect from the power
supply before cleaning heater
· For general cleaning use a soft clean
duster-never use abrasive cleaners. The
glass viewing screen should be cleaned
carefully with a soft cloth. DO NOT use
proprietary glass cleaners.
Technical Specification
· Supply: 220-240V ~ 50Hz
· Rated power: 2000W
· Lighting: 40Wx3 G9 Clear Candle bulb
 These specifications are subject to
change without notice
20
Solution
Check fuse by replacement.
Check for safety cut-off
operation.
Check the bulb by replacement.