Warm Tech FES2000-MIG2 Traduction Des Instructions D'origine page 18

Installation (see Fig. 1~Fig. 4)
· Do not connect the appliance until properly
fixed to the wall and the instructions is read
fully.
· The minimum distances must be observed.
· For installation of the appliance, care must be
taken not to damage concealed cables.
· Please be careful while drilling the holes.
· This appliance is designed to be permanently
fixed to a wall at a minimum height of
300mm.The wall bracket must be fitted
horizontally and the cable routed to the
bottom right of the heater.
· A height of 600mm from bottom of heater to
floor is recommended for optimum viewing
of fuel bed（see Fig.2 for recommend fixing
dimensions）.
· For optimum viewing, mark the top four
screws fixing positions on wall in
accordance with the recommend fixing
dimensions- see Fig.2.Drill holes with a six
drill bit.
· Fix the wall bracket using that the plug and
screws provided .
· Carefully lift the heater up ensuring that the
top rear ledge of heater engages the wall
bracket (see Fig.2 in circle) and is sitting
centrally.
· Gently bring the heater level with the wall.
· Mark the bottom holes position-see Fig.3,
remove the heater ensuring that the bottom
fixing bracket is rotated up.
· Drill and fit wall plug.
· Refit the heater to the wall fixing bracket and
rotate the bottom fixing bracket down again
and use the screw provided to permanently
fix the heater in place.
· Unpack the pebbles from the bag and place
them along the light unit in the desired Position.
· Place the front glass surround over the front of
the fire aligning the slots in the brackets at
each side of the glass panel with the lugs
on the sides of the fire-see Fig.4. Again two
people will be required for this operation.
Replacing the Lamp
(see fig. 5 and fig. 8)
· Warning-Always disconnect from the power
supply before removing bulb.
· Warning-The bulbs reach high temperatures
during operation. Allow the bulbs to cool
down after switching off the appliance
before changing lamps.
· Note: Two people will be required for this
process.
· It is recommended that the fire is carefully
removed from the wall and laid on its back
in order to replace the lamp.
· Gently slide the front glass panel towards the
top of the fire and remove. Store the glass
safely out of the way whilst the bulb is replaced
so that it does not get damaged.
· At the bottom of fire, there is a lamp cover
fixed by eight Philip's head screws, remove
the eight screws and lift off the lamp
cover-see Fig.5.
· For access to the bottom bulbs, carefully slide
the flexible rotisserie to one side ensuring
that the rubber grommet is not lost-see
Fig.6
· Remove the defective bulb by unscrewing it.
Fig.7
· Replace with a 40W G9 Clear Candle bulb,
rotating it. Take care not to over-tighten the
bulb.
· Refit the rotisserie making sure that the
rubber grommet is carefully pushed into the
slotted hole on the axial bracket.
· Lift the fire back onto the wall and replace the
glass front by lifting onto the lugs either
side of the fire.
18