Velleman AVMOD19 Mode D'emploi page 8

IR LED [L] in front of the IR receiver of the signal transmitting device,
maximum distance ±50cm (±20"), angle +/-15°.
•
Plug the power plug of the included AC power adaptor [K] into the power
connector [F]. Only use the included adaptor or one with the same
specifications.
•
Make sure the power switch [C] is in the OFF-position and plug the adaptor into
a suitable mains outlet.
Receiver [6]
•
Use the SCART-to-RCA A/V cable marked with RECEIVER (included) or use an
appropriate S-video cable (not included).
Note: when using an S-video cable on the transmitter side, an S-video cable
must also be used on the receiver side.
•
Connect the RCA video connector (yellow) to the video connector [H] and
connect the audio connectors (red, white) to the audio connectors [I] resp.
[J]. When using an S-video cable, simply connect it to the S-video connector
[G].
•
Connect the SCART connector to a SCART input connector or connect the free
end of the S-video cable to the S-video output port of a TV, monitor ... (not
included).
•
Plug the power plug of the included AC power adaptor [K] into the power
connector [F]. Only use the included adaptor or one with the same
specifications.
•
Make sure the power switch [C] is in the OFF-position and plug the adaptor into
a suitable mains outlet.
7. Operation
•
Switch on the receiver and transmitter [C].
•
Fold the antennas upwards and position them in such a way that the side with
the grooves of the receiver and transmitter antennas face each other [7]. This
will guarantee best performance.
Notes:
- The antenna does not rotate 360°. Do not force or rotate past the
protrusion or permanent damage will occur.
- Avoid obstacles between the antennas as this will decrease performance.
- Keep the distance from transmitter to receiver antenna as short as possible.
•
Use the channel selector switch [B] to set the channel. Select a channel
depending on noise or interference conditions. Always set the same channel on
transmitter and receiver.
•
Point the remote control towards the receiver (see [8]) to control the
transmitting device(s). In case interference with other IR devices is noticed, set
the remote frequency selector [E] in the other position. In A-mode, the carrier
frequency is 38KHz; in B-mode 56KHz.
01.09.2010
AVMOD19
8
©Velleman nv