Adjusting Control Settings; Refrigerator Features; Ice Maker Storage Bin - Whirlpool Estate TS22AQXGN01 Guide D'utilisation Et D'entretien

Adjusting Control Settings

Give the refrigerator time to cool down completely before
adding food. It is best to wait 24 hours before you put food
into the refrigerator. The settings indicated in the previous
section should be correct for normal household
refrigerator usage. The controls are set correctly when milk
or juice is as cold as you like and when ice cream is firm.
If you need to adjust temperatures in the refrigerator or
freezer, use the settings listed in the chart below as a
guide. Wait at least 24 hours between adjustments.
CONDITION/REASON:
REFRIGERATOR section
too warm
Door opened often
Large amount of food added
Room temperature very warm
FREEZER section too warm/ice
not made fast enough
Door opened often
Large amount of food added
Very cold room temperature
(can't cycle often enough)
Heavy ice usage
Air diffuser blocked by items
REFRIGERATOR section
too cold
Controls not set correctly for
your conditions
FREEZER section too cold
Controls not set correctly for
your conditions
12
RECOMMENDED
ADJUSTMENT:
Turn
REFRIGERATOR
Control one-half
setting higher,
wait 24 hours,
then check the
freezer
temperature
Turn FREEZER
Control one-half
setting higher
Move packages
out of airstream
Turn
REFRIGERATOR
Control to next
lower number
Turn FREEZER
Control one-half
setting lower
REFRIGERATOR
FEATURES

Ice Maker Storage Bin

To remove the ice bin:
1. Pull the covering panel out from the bottom and then
slide it back toward the rear.
2. Lift the signal arm so it clicks into the OFF (up) position.
Ice can still be dispensed, but no more can be made.
3. Lift up the front of the storage bin and pull it out.
4. Empty the ice bin. Use warm water to melt the ice if
necessary. Never use anything sharp to break up the
ice in the bin. This can cause damage to the bin and
the dispenser mechanism.
5. Wash with a mild detergent, rinse well and dry
thoroughly. Do not use harsh or abrasive cleaners or
solvents.
6. When you replace the bin, make sure it is pushed in
all the way or the dispenser will not work. Then push
the signal arm down to the ON position to restart ice
production. Make sure the door is closed tightly.