BG 85, SH 85
1
4
2
Move the stop switch (1) to the run
N
position I.
Squeeze the throttle trigger (2) and
N
move the setting lever (4) to midway
position at the same time.
Release the throttle trigger – this is
N
the starting throttle position.
The setting lever enables you to select
and hold any throttle position between
idle and full throttle. Move the setting
lever to the idle position before shutting
off the engine.
BG 55, BG 65, BG 85, SH 55, SH 85
All models
Setting the choke lever
6
Press the manual fuel pump
N
bulb (6) at least five times – even if
the bulb is filled with fuel.
If the engine is cold
5
Set the choke lever (5) to g.
N
Pull the starter rope five times.
N
Set the choke lever (5) to e.
N
Continue cranking until the engine
N
runs.
If the engine is warm
Set the choke lever (5) to e.
N
Also use this setting if the engine has
been running but is still cold.
Cranking
Place the unit on the ground so that
N
it is secure.
Make sure you have a firm footing:
N
Hold the unit firmly with your left
hand on the housing and press
down.
Hold the starter grip with your right
N
hand.
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
NOTICE
Do not pull out the starter rope all the
way – it might otherwise break.
English
13