Operating Instructions - Kapro Prolaser 895 All-Lines Manuel D'utilisation

Operating Instructions

To get the most out of your Prolaser
carefully to the following instructions.
Note
heavy machinery or sources of vibration that may adversely
affect the leveling of the laser.
Horizontal and Vertical Lines, Plumb Down Dot
The 895 Prolaser
4 vertical lines on walls, floor and ceiling (5 intersecting cross lines,
including one on the ceiling). It also projects a plumb down dot.
1. Set up the laser level approximately level on a flat, vibration-free
surface or a tripod. The laser level can compensate for up to ± 3°
from the horizontal plane.
2. Adjust support legs until surface level is centered.
3. Unlock the safety lock by twisting the knob on the side of the laser.
The power LED will light.
4. Press one of the Output Control buttons on the keypad on the top of
the unit. The laser level will generate 1 horizontal, 2 vertical lines and
a plumb down dot. If it is set up outside the ± 3° self-leveling range
the laser beam will flash and an alarm will sound.
5. Press second Output Control button to generate additional lines
(1 horizontal, 2 vertical) on the opposite wall.
Avoid setting up the laser level near
All-Lines laser level can project 2 horizontal and
®
895 All-Lines, please adhere
®
9