Zenoah GZ3500T Manuel D'utilisation page 19

3. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
4. Start the chainsaw and apply full throttle.
5. Release the throttle trigger and make sure that the
saw chain stops and stays stationary.
WARNING: If the saw chain rotates
when the throttle trigger is in the idle
position, speak to your servicing dealer.
To do a check of the chain catcher
1. Make sure that there is no damage on the chain
catcher.
2. Make sure that the chain catcher is stable and
attached to the body of the product.
To do a check of the vibration damping
system
1. Make sure that there are no cracks or deformation
on the vibration damping units.
2. Make sure that the vibration damping units are
correctly attached to the engine unit and handle unit.
Product overview on page 2 for information
Refer to
about where the vibration damping system is on your
product.
To do a check of the start/stop switch
1. Start the engine.
308 - 007 - 05.11.2019
2. Push the start/stop switch to the STOP position. The
engine must stop.
To do a check of the muffler
1. Loosen the screws (A and B).
A
2. Remove the muffler cover.
3. Loosen the screws and nuts.
4. Remove the muffler and make sure that it is not
defective.
B
19