Battery Compartment - Siemens RDH100 Instructions D'installation Et D'utilisation

Operating instructions
DE
The RDH100 is a room thermostat that allows you to set the desired room temperature (setpoint) for the desired
EN
time. The unit features an ergonomic setting knob for easy temperature control.
FR
Display
IT
Actual room temperature in ºC
NL
The unit controls to the selected
ES
comfort temperature
Indicates when heating is
PT
demanded
CS
Replace batteries
HU
PL
SV
FI

Battery compartment

ZH
2 alkaline batteries type AA, 1.5 V
TR
EL
RO
DA
/
A6V101035984_en--_a 2017-01-01
RDH100
Commissioning
·
Remove the black transit tabs from the 2 alkaline batteries. Check to see if the
battery compartment is in its correct position
·
If no batteries are inserted, fit 2 alkaline batteries type AA in the battery
compartment
Subject to alteration
Setting knob
Warmer/colder knob for
selecting the temperature
setpoint
Changing the batteries
Energy saving tips without sacrificing comfort
Initial power-up
Once batteries are inserted, all symbols are
displayed as shown for about 2 seconds.
Selecting the required temperature
·
Turn the setting knob counter-clockwise to
decrease the setpoint, or clockwise to
increase the setpoint in increments of 0.5 °C
·
The required temperature is displayed next
to the comfort temperature symbol
1. Get 2 new alkaline batteries type AA, 1.5 V.
2. Within 1 minute: pull out the battery compartment and remove
the batteries, insert the new batteries and replace the battery
compartment.
3. Make certain the old batteries are disposed of properly,
in compliance with environmental requirements.
·
Never allow room temperatures to exceed 21 ˚C
·
Air out rooms for short periods of time only, but properly,
with the windows wide open
Siemens Building Technologies / HVAC Products