HQ Power PROMIX1212E Notice D'emploi page 7

24. G1-2 OUT
A channel's output will be routed to the G1-2 GROUP OUTS (24) by depressing the G1-2 selection switch
(14). These outputs are ¼" TRS balanced phone jacks wired: tip = +, ring = -, sleeve = ground.
25. CTRL R OUT
The L-R control room outputs can be connected to an amplifier to power stereo control room (or other)
monitor speakers and are ¼" unbalanced phone jacks wired: tip = +, sleeve = ground.
26. MONO OUT
This jack outputs a monaural mix of the stereo signal from the ST bus. The level for this output is controlled
by the MONO fader in the master control block. The output is a mix of the ST bus's L and R signals. This is
best suited for use with a mono sound system or for the addition of a subwoofer to your set of speakers,
adding much more punch to low frequencies. This is a ¼" unbalanced phone jack wired: tip = +, sleeve =
ground.
27. STEREO OUT
The stereo outputs consist of both left (L) and right (R) balanced XLRs, wired: pin 1 = ground, pin 2 = hot +,
pin 3 = cold -, and ¼" unbalanced phone jacks wired: tip = +, sleeve = ground.
28. TAPE IN
These jacks will accept the signal from an external device with a stereo output such as a cassette recorder.
29. REC OUT
The REC outputs also provide an output of the MASTER MIX. These outputs are RCA jacks and designed
primarily for inputs to tape recorders, etc.
30. PHONES OUT
The PHONES output will feed headphones and is a ¼" TRS jack, wired as tip = left signal, ring = right
signal, sleeve = ground.
31. MAIN POWER Switch
This switch is used to turn the mixer on or off. Make sure to turn all level controls down before activating.
32. POWER ON LED
This LED will light when the mixer is on.
33. FOOTSWITCH Jacks
Connect the footswitch to the mixer through this jack. The footswitch is used to turn the digital effects
processor on or off. The ¼" TRS (stereo) plug should be wired: tip = FX 1, ring = FX 2, sleeve = ground.
34. GROUP Controls
These two faders control the final level of the signals sent to the main L and R outputs.
35. MONO FADER
This fader adjusts the signal level feeding from the ST bus into the MONO output jack.
36. L/R MASTER FADERS
These two faders control the final level of the signals sent to the main L and R outputs.
37. AUX RETURN
These controls adjust the signal level of audio fed through the stereo AUX RETURN inputs.
PROMIX1212E_v2
7 HQPOWER