UFESA FR1215 Mode D'emploi page 6

ENGLISH
1. Lid with inspection window
2. Basket
3. Handle on the basket
4. Detachable control module
5. Heating element
6. ON/OFF button
7. On/Off pilot lamp
8. Thermostat pilot lamp
9. Temperature selector
10. Detachable pan
11. Body
12. Carrying handles
13. Cable coiler
14. Reset button
IMPORTANT NOTES
• Read through the instructions carefully before
using the appliance for the first time. Safeguard
them for future reference.
• Before plugging the appliance into the mains,
check that the voltage corresponds to that stats s
ed on the characteristics plate. Use an electrical
socket with an earth connection
• Never immerse the electrical parts in water or
any other liquid.
• Before filling the fryer with oil or fat make sure
that all of the pieces are completely dry and that
there is no water in the pan or on the heating
element.
• Never switch the fryer on before it has been
filled with oil or fat. The amount of fat or oil used
should always be between the minimum and
maximum marks. Check that there is still enough
oil or fat in the pan before any further frying.
• Only use oils and fats recommended for fryers.
When fresh fat/lard in blocks or pieces is being
used, melt it down in a saucepan beforehand
and then pour it into the fryer before switching it
on.
• Do not overfill the basket as this may cause the
hot oil or fat to spill over the top of the fryer.
• This appliance is not intended for use by pers s
sons (including children) with reduced physical,
sensory or mental capabilities, or lack of experis s
ence and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
• The apliance is not intended to be operated
by means of an external timer or separate
remotescontrol system.
• The steam given off during frying is very hot.
Keep a safe distance away from this steam.
• Avoid moving the fryer while it is operating.
• Do not touch the hot surfaces. Use the handles
or controls.
• After use put the switch to the "O" position,
unplug the fryer from the mains and leave it until
it is cool enough to be moved.
• Always unplug the fryer when it is not in use
and before cleaning it.
• Never unplug it by tugging on the mains cable.
Never leave the mains cable hanging freely.
• Keep the fryer and the cable away from hot
surfaces.
• Never use the fryer for purposes other than
those stated in this manual.
• Do not use the fryer appliance if either the
cable or plug are damaged. Cable repairs and
replacements must be carried out exclusively by
an Authorised Technical Service Centre.
• This appliance has been designed exclusively
for domestic use.
SAFETY
The fryer is equipped with a safety thermostat
that switches off the electric supply should it
become too hot. If this happens:
Leave the fryer to cool down
Carefully push the reset button back in with the
help of a small rod. This button, marked "Restart",
is found at the back of the control panel, figure
1.
To prevent the plug from being damaged, store
the mains cable in the cable compartment.
The fryer is also equipped with a safety tri p
switch that stops the heating element from
working if the control module is not fitted into
its housing correctly.
Always keep children away from fryers when
they are switched on.
USE
Before using the appliance for the first time,
wash the basket, pan and lid in hot soapy water
and then rinse and dry them.
1. Place the fryer on a flat, stable surface. Pull the
cable fully out of the cable compartment maks s
ing sure that it is not touching any nearby heat
sources
2. Use the plastic handle to lift off the lid.
3. Take out the basket.
4. Fill the pan with oil. The oil or fat level should
always be kept somewhere between the minis s
mum and maximum marks:
FR1215: MIN. (1,5 litres) and MAX. (2 litres).
FR1225: MIN. (2.5 litres) and MAX. (3 litres).
5. Plug the appliance into the mains and press
the on/off switch. The pilot lamp will light up,
fig. 2
6. Select the correct temperature for the food to
be fried. The thermostat green lamp will go, fig.
3 out as soon as the appliance has reached the
selected temperature.
7. Place the basket into the drainsoff position,
figure 4. Place the food to be fried inside the
basket. Do not overfill the basket.
Slowly lower the basket with the food into the
oil, figure 5. Place the lid on when frying
8. After frying, switch the fryer off ("0" position)
and unplug the fryer from the mains supply.
9. P lace the basket into the drainsoff position.
Note: If various foodstuffs are to be fried, wait
for the oil to reach the set temperature between
fries. Always check the immersion level before
each use. The ideal oil level is somewhere bes s
tween the MIN and MAX limits marked on the
side of the frying pan.
RECOMMENDATIONS
Ufesa recommends the use of oil instead of fat
when using this appliance. Solid fat can also be
used but special precautions should be taken to
stop it from splashing when it is melting.
Do the following when using solid fat for frying:
1. Before the first fry, melt the fat for the fryer in
a separate saucepan on a low heat.
2. Pour the liquid fat into the fryer's pan. Avoid
splashing it.
3. Check that the liquid fat covers the minimum
level mark. Switch the fryer on and carry out the
frying.