Teac UD-505 Mode D'emploi page 17

Upconversion information displayed
Press the INFO button during playback to show input signal upcon-
version information.
o The input signal and playback signal displays will be the same
when the upconversion setting is "OFF".
Example when the playback source is USB, COAX1, COAX2,
OPT1 or OPT2
Input signal
format
PCM
44. 1kHz
Input signal sampling
frequency
Example when the playback source is Bluetooth
Codec
LDAC
44. 1kHz
Input signal sam-
pling frequency
Volume display
Two types of volume can be shown: STEP and dB.
This is set by the VOLUME TYPE setting (page 26).
The volume setting shown will be enlarged when you turn this unit's
VOLUME knob.
o The headphone volume is shown when headphones are
connected.
VOLUME TYPE set to "STEP (0–99)"
Display example
VOL.
The maximum volume level is 99 and the minimum level is 0.
Before connecting headphones, set the VOLUME knob to its
minimum value (0). Failure to do so might cause sudden loud
noises, which could harm your hearing or result in other trouble.
Playback signal
format
DSD
11. 2MHz
Playback sampling
frequency
Playback signal
format
PCM
352. 8kHz
Playback sam-
pling frequency
36
VOLUME TYPE set to "dB"
Display example
VOL.
The maximum volume level is 0 and the minimum level is −∞
(negative infinity). Before connecting headphones, set the
VOLUME knob to its minimum value (−∞). Failure to do so might
cause sudden loud noises, which could harm your hearing or
result in other trouble.
The set output level is shown when LINE OUT LEVEL is set to "FIXED
0dB" or "FIXED +6dB".
Example when VOLUME TYPE set to "dB"
USB
o If VOLUME TYPE is set to "STEP (0–99)", "VOL. 85" will be shown
when set to "FIXED 0dB" and "VOL. 89" will be shown when set to
"FIXED +6dB".
When headphones are not connected and LINE OUT LEVEL is set to
"OFF", "VOL. 0" or "−∞ dB" will be shown.
Example when VOLUME TYPE set to "dB"
USB
When headphones are not connected and LINE OUT LEVEL is
set to FIXED or OFF
Turning the VOLUME knob will cause the following to be displayed.
LINE OUT LEVEL set to FIXED
VOL.
LINE OUT LEVEL set to OFF
VOL.
-62
.0dB
+ 0.0
dB
− ∞
dB
FIXED
OFF
EN
17