Installation Procedures; Electric Installation; Pneumatic Installation - Hofmann monty 1620 Mode D'emploi

62
monty 1620 - 1625
iii Installation procedures

Electric installation

THE INSTALLATION SHALL BE CARRIED OUT
ONLY BY QUALIFIED PERSONNEL AND WITHIN
THE SCOPE OF THE INSTRUCTIONS PROVIDED
IN THIS MANUAL.
Check on the plate of the machine that the electrical
specifi cations of the power source are the same as
the machine.
The machine uses
120 VAC, 60 Hz, 12 A
1 phase motor.
Electrical specifi cations are clearly marked on a label
at the end of the electric cable.
Before connecting the machine to the power source
check that the power supply has an effi cient earthing
system.
Connect the electric cable of the machine with an
approved plug.
Note:
Note:
Check that the power supply has an automatic circuit
breaker with a diff erential circuit rated at 30 mA.
The electric motor operates in a wide voltage range
(plus or minus 10%) and frequency range (60 Hz) and
has a class of insulation suitable for hot and moist
climates.
NOTE: AIR MOTOR POWERED MACHINE DOESN'T
NEED ELECTRICAL INSTALLATION.

Pneumatic installation

THE AIR INSTALLATION MUST BE PERFORMED
ONLY BY LICENSED PERSONNEL.
The machine requires an air pressure of 8 to 12 bar
(110-170 psi), as marked on the plate of the machine
and on a sticker attached to the cabinet next to the
air inlet.
Ensure that the line pressure is within the limits
required by the machine.
If the air pressure is lower than the minimum required
of 8 bar (110psi) the clamping power of the turntable
and the bead breaker power may be insuffi cient for
certain tIres.
If the air pressure exceeds 12 bar (170 psi) it is
mandatory to install a pressure regulator before the
air inlet of the machine.
Operator's Manual
The outlet installation must be verifi ed by
a licensed electrician before connecting
the tire changer.
The yellow/green wire in the cable is the
earth wire. Never connect the earth wire
to a live terminal.