Charging Procedure; Checking The Charger - McCulloch Li 402A Manuel D'utilisation

Charging Procedure

NOTE: The battery is not shipped fully charged. It is
recommended to fully charge before use to ensure that
maximum run time can be achieved. This lithium-ion
battery will not develop a memory and may be charged
at any time.
• Plug the charger into an AC power outlet.
• Insert the battery pack (1) into the charger (2).
• This is a diagnostic charger. The Charger LED Lights
(3) will illuminate in specific order to communicate
the current battery status. They are as follows:
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING:
FULLY CHARGED:
BATTERY IS TOO WARM:
(REMOVE FOR APPROX. 30
MINUTES TO ALLOW TO COOL)
NO BATTERY PRESENT:
DEFECTIVE BATTERY:
(REMOVE AND REPLACE WITH
NEW BATTERY IF THIS OCCURS)
False Defect Note:
When the battery is inserted into the charger, and
the status LED flashes, remove the battery from the
charger for 1 minute, then reinsert. If the status LED
indicates normal then the battery pack is good. If the
status LED is still blinking, remove the battery pack and
unplug the charger. Wait 1 minute and plug the charger
back in and reinsert the battery pack. If the status
LED indicates normal than the battery pack is good. If
the status LED is still blinking then the battery pack is
defective and needs to be replaced.
NOTE: When the red indicator flickers, pull out the
battery from the charger and insert again within 2
hours. If the indictor shows charging, that means
the battery is good. After 2 hours, please pull out the
battery and also pull out the AC power plug of the
charger for 1 minute, and then insert the AC power plug
and the battery again. If the indictor shows charging,
that means the battery is good. If not, the battery needs
8 - English
CHARGING PROCEDURE
RED RED
RED
GREEN
RED
ORANGE
RED OFF
RED
RED
BLINKING
to be changed.
WARNING! Changes or modifications
!
to this unit not expressly approved by
the party responsible for compliance
could void the user's authority to
operate the equipment.

Checking the Charger

If the battery pack does not charge properly:
• Check the current at the power outlet with another
tool. Make sure that the outlet is not turned off.
• Check that the charger contacts have not been
shorted by debris or foreign material.
• If the surrounding air temperature is not normal room
temperature, move the charger and battery pack to a
location where the temperature is between 6 ˚C and
40˚C.
WARNING! If the battery is inserted
!
into the charger when warm or hot,
the CHARGING LED indicator light
on the charger may switch on and
illuminate ORANGE. If this occurs
allow the battery to cool outside of
the charger from approximately 30
minutes.