Assembly Instructions - Texas Hobby 300 Manuel De L'utilisateur

Assembly instructions:

Package contents:
The machine comes in a cardboard box,
which contains a basic module, various
parts, and a manual.
Carefully unpack the box and check the
diagrams to see that none of the parts are
missing.
Rotor blades, depth skid and wheel
bracket:
Fit the two identical rotor blades to the gear
shaft with the cotter bolt, which is locked by
a cotter pin.
Then fit the depth skid and wheel clamp
using the two cotter bolts supplied.
Assembly of lower handle:
Fit the two lower handle tubes on the chassis
first. Pull the long steel bolt out of the
chassis and gear. Then push the two tubes
through the holes and replace the long bolt.
REMEMBER to tighten the bolt.
Assembly of upper handle:
Now fit the upper handle using the plastic
adjusting screws. Note that these are marked
with a pivot point, which must face each
other (as shown by the arrows) for the
handle to function correctly.
Gear cable and throttle cable:
The gear cable and lever are fitted on the
right side of the handle, and the throttle
cable on the left side.
Oil and petrol:
Oil and petrol are not included with the
machine. Fill the motor with 0.6 litres of
SAE 30 motor oil and octane 92 or 95
unleaded petrol.
For further information about the motor, see
the attached motor manual
Note Oil and petrol are not included
.
10
92/95 Octane
SAE 30 Oil