Notice For The Blue/White Lead; Parts Supplied - Pioneer AVIC-HD3II Manuel D'installation

Section
02 Connecting the System
! If [Auto ANT] mode is set to [Power], the
vehicle's aerial can be stowed or turned off
only when the ignition switch is turned off
(ACC OFF).
! Do not connect this lead to the system con-
trol terminal of external power amps.
! Be sure not to use this lead as the power
supply lead for the auto-aerial or aerial
booster. Such connection could cause ex-
cessive current drain and malfunction.

Notice for the blue/white lead

! When the ignition switch is turned on (ACC
ON), a control signal is output through the
blue/white lead. Connect to an external
power amp's system remote control term-
inal (max. 300 mA 12 V DC). The control sig-
nal is output through the blue/white lead,
even if the audio source is switched off.
! Do not connect this lead to the auto-aerial
relay control terminal or the aerial booster
power control terminal.
! Be sure not to use this lead as the power
supply lead for the external power amps.
Such connection could cause excessive
current drain and malfunction.
6
Engb

Parts supplied

The navigation unit
Connector
Extension lead
(for speed signal)
RCA connector 1
(CONNECTOR 1)
<See page 10, 14, 17>
Microphone
Power cord
<See Page 10, 12, 16>
Extension lead
(for reverse signal)
GPS aerial
RCA connector 2
(CONNECTOR 2)
<See Page 8, 12, 16,
18>