Connecting The Power Cord (1) - Pioneer AVIC-HD3II Manuel D'installation

Section
02 Connecting the System

Connecting the power cord (1)

Note
Depending on the kind of vehicle, the function
of *3 and *5 may be different. In this case, be
sure to connect *2 to *5 and *4 to *3.
Cap (*1)
When not using this terminal,
do not remove the cap.
ISO connector
Yellow/black
If the vehicle can send a mute signal to this terminal, the
mute function can be activated on this navigation system
when the terminal is connected to *8.
Note
In some vehicles, the ISO connector may be divided into two.
In this case, be sure to connect to both connectors.
10
Engb
*1
*3 *2
*5 *4
Yellow (*3)
Yellow (*2)
Back-up
To terminal always supplied
(or accessory)
with power regardless of
ignition switch position.
Red (*4)
Red (*5)
Accessory To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
(or back-up)
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Notes
· When a subwoofer (*9) is connected to this
navigation system instead of a rear speaker, change
the rear output setting in the Initial Setting. (Refer to
the operation manual.) The subwoofer output of this
navigation system is monaural.
· When using a subwoofer of 70 W (2 Ω), be sure to
connect with violet and violet/black leads of this
navigation unit. Do not connect anything with green
and green/black leads.
Connect leads of the
same colour to each
other.
Fuse holder
Fuse (10 A)
Speaker leads
White: Front left
White/black: Front left
Grey:
Front right
Grey/black: Front right
Green:
Rear left
Green/black: Rear left
Violet:
Rear right
Violet/black: Rear right
or Subwoofer (*9)
or Subwoofer (*9)
or Subwoofer (*9)
or Subwoofer (*9)