Tips & Troubleshooting - Gallagher S100 Notice D'installation

TIPS & TROUBLESHOOTING
• Install energizer where it can get plenty of sunlight.
• Keep solar panel clean - periodically use a so cloth with water and a mild
detergent.
• Test voltage on the fence using a Gallagher Fence Volt Meter (G50301).
• Turn energizer off before handling fence or ba ery connec ons.
Symptom Problem
Ba ery Ba ery capacity
indicator is is low due to
solid red insuffi cient sunlight.
The energizer will
slow down to use
less power and
allow ba ery to
charge.
Ba ery No ba ery or an
indicator incorrect ba ery is
fl ashes red connected.
Fence Output voltage is
Voltage too low, due to a
indicator high load on the
fl ashes red fence line.
No voltage Energizer may have
on fence been damaged by
lightning.
10
3E4208 Gallagher S100 Solar Energizer User Manual
Solu ons
• Ensure energizer is ge ng enough sun.
• Turn energizer off for 3 days leave in sun
to charge ba ery.
• Remove ba ery and use a 12 V 1.2 A
charger to charge ba ery.
• Connect the correct ba ery.
• Check ba ery is OK using the ba ery
check func on.
• Check fence and earth system for faults.
Check energizer isn't faulty;
• disconnect from fence and earth
• measure across fence and earth terminals
with a Gallagher Fence Volt Meter
- if less than 5 kV return energizer for
service
- if more than 5 kV the fault is with the
fence or earth system.