Attaching The Front Handle; Assembling The Tool; Operation - Ryobi P2705 Manuel D'utilisation

ATTACHING THE FRONT HANDLE

See Figure 3.
 Loosen and remove the wing nut and bolt from the handle.
 Install the handle on the rear handle pole in the area
indicated by the illustration.
 Adjust handle up or down, if necessary, to desired
operating position.
 Reinstall the wing nut and bolt. Tighten wing nut to secure.

ASSEMBLING THE TOOL

See Figure 4.
WARNING:
Never assemble the cultivator with the battery pack in-
stalled. Failure to stop the motor or remove the battery
pack can result in serious personal injury.
 Remove the battery pack if installed.
 Align the two indentations in the upper end with the screws
in the lower end. Insert the upper end into the lower end.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
ASSEMBLY
 Push the two sections together until the upper end stops.
 Turn each of the two screws until securely tightened.
WARNING:
Be certain the ends are locked into place before operating
cultivator; check it periodically for tightness during use to
avoid possible disconnection of ends, which could result
in serious personal injury.
CAUTION:
Be careful when sliding the two ends together to avoid
pinching the cable, your hands, or fingers.
WARNING:
This cultivator is designed to use only the provided
lower and upper ends. It is not capable of using other
attachments or cutting heads. Attempting to use other
attachments or cutting heads could result in serious
personal injury.

OPERATION

WARNING:
Do not allow hands, feet, or any other part of the body or
clothing near the oscillating tines or any other moving part.
The tines begin to oscillate once the lock-out button is
depressed and switch trigger is pulled. The tines continue
to oscillate until the switch trigger is released. Failure
to avoid contact could cause serious personal injury.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts,
caps, etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced. Please contact customer service or
a qualified service center for assistance.
6 — English