Installation; Before The Installation; Connection Cable - Electrolux EHL6740F9K Notice D'utilisation

16 www.electrolux.com
Problem
comes on.
comes on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also three
digit letter code for the glass ceramic (it is
in the corner of the glass surface) and an

8. INSTALLATION

8.1 Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.
Serial number ...........................
8.2 Built-in hobs
Only use the built-in hobs after you
assemble the hob into correct built-in units
and work surfaces that align to the
standards.

8.3 Connection cable

• The hob is supplied with the
connection cable.
WARNING!
Refer to Safety chapters.
Possible cause
The cooling fan is blocked.
The electrical connection is
incorrect. The hob is con-
nected only to one phase.
error message that comes on. Make sure,
you operated the hob correctly. If not the
servicing by a service technician or dealer
will not be free of charge, also during the
warranty period. The instructions about
the Service Centre and conditions of
guarantee are in the guarantee booklet.
• Replace the damaged mains cable only
with the spare parts cable. Speak to
your local Authorised Service Center.
Remedy
Check if objects block the
cooling fan. If
on again, speak to an Au-
thorised Service Centre.
Speak to a qualified electri-
cian to check the installa-
tion. Refer to the connec-
tion diagram.
WARNING!
All electrical connections
must be made by a qualified
electrician.
CAUTION!
Do not drill or solder the wire
ends. This is strictly
forbidden!
CAUTION!
Do not connect the cable
without cable end sleeve.
comes