Publicité
Les langues disponibles
Les langues disponibles
ACOUSTASONIC 30 - FRONT PANEL
1. INSTRUMENT - Plug your guitar in here.
2. VOLUME - Adjusts the loudness of the instru-
ment channel.
3. TREBLE - Adjusts the high frequency range of
the instrument channel.
4. MID - Adjusts the middle frequency range of
the instrument channel.
5. BASS - Adjusts the low frequency range of the
instrument channel.
6. REVERB SWITCH - Press this switch in to
activate the reverb effect on the instrument
channel. •NOTE: The (15) REVERB CONTROL
must be rotated clockwise for any reverb effect
to be heard.
7. STRING DYNAMICS (PATENTED) - Controls a
tone shaping filter on the instrument channel.
Rotating this control clockwise decre a s e s
h i g h - f requency "harshness" while playing
loudly and maintains "crispness" while playing
softly.
8. CHORUS SWITCH - Press this switch in to
activate the chorus effect on the instrument
channel. •NOTE: Connecting the footswitch
will override this chorus switch.
9. CHORUS CONTROL- Rotating this contro l
clockwise increases the modulation rate of the
chorus effect.
10. CHORUS INDICATOR - This LED illuminates
when the chorus effect is active and increases
in brightness with the chorus modulation rate.
11. MIC - Plug your microphone in here. Use this
three-pin XLR balanced female input connec-
tor
with
low
impedance
•NOTE: +15V DC phantom voltage supplied.
12. VOLUME - Adjusts the loudness of the mic
channel.
13. TREBLE - Adjusts the high frequency range of
the mic channel.
14. BASS - Adjusts the low frequency range of the
mic channel.
15. REVERB CONTROL - Adjusts the reverb effect
on both channels when the (6) REVERB
SWITCH is pressed in. Adjusts only the mic
channel reverb effect when the (6) REVERB
SWITCH is pressed out. •NOTE: This control
must be rotated clockwise for any reverb effect
to be heard.
16. PHASE - Reverses the phase (180
amplifier when this switch is pressed, eliminat-
ing feedback when playing in small spaces.
17. F O O T S W I T C H
footswitch (Part# 037659) here. The footswitch
enables remote on/off switching of the chorus
effect. •NOTE: Connecting the footswitch will
override the (8) CHORUS SWITCH.
unshielded speaker type patch cord is prefer-
able to a coax guitar cord for connecting the
footswitch.
18. LINE OUT - This 1/4 inch phone jack provides
a line-level, post-effects, unbalanced output
(tip is send, ring is ground) for direct connec-
tion to re c o rding and sound re i n f o rc e m e n t
equipment.
19. POWER INDICATOR - This LED illuminates
when the amplifier is ON.
20. POWER SWITCH - Press in the bottom of this
switch to turn the amplifier ON. Press in the
top of this switch to turn the amplifier OFF.
micro p h o n e s .
4
o
) of the
-
Plug
in
the
optional
An
Publicité
