Water Tap; Disposal, Scrapping - Husqvarna K 4000 Cut-n-Break Manuel D'utilisation

• Remove the inspection cover by loosening both
screws.
• Unscrew the cable holding the carbon brush. Now lift
up the spring and then lift out the carbon brush from
the brush retainer.
• Clean the brush retainers with a dry brush.
• Carefully blow away the dust.
• Fit the new carbon brushes and, at the same time,
check that they slide easily in the brush retainers.
• Fold down the springs and tighten the cable.
• New carbon brushes must be run in for approximately
40 minutes while idling.

Water tap

• Check and clean the restrictor if necessary. Do not
use hoses that are distorted, worn or damaged.

Disposal, scrapping

This product should be submitted to an appropriate
recycling station in accordance with local requirements.
By ensuring that this product is taken care of correctly,
you can help to counteract the potential negative impact
on the environment and people that can otherwise result
through the incorrect waste management of this product.
For more detailed information about recycling this
product, contact your municipality, your domestic waste
service or the shop from where you purchased the
product.
MAINTENANCE
–
English 21