Maintenance - Depuragua RO N02T Notice D'installation Et De Maintenance

MANUAL/NOTICE DÌNSTALLATION/MANUALE DI INSTALLAZIONE (MODELS RO N02T)

8. MAINTENANCE

To ensure that the system works at its optimum level, you must perform certain maintenance
routines. Maintenance frequency will depend on the level of use, as well as the quality of the inlet
water
8.1 Membrane Cleaning:
This unit has an automatic cleaning system, it will clean the membrane every 8 hours of running
8.2 Filter replacement:
Replace PP33 pre filter every 3 to 6 months depending on the quality of the raw water and
consumption.
Replace GAC33 pre filter and CTO33 every 6 to 12 months.
Replace membrane every 24 to 36 months, in areas of hard water replacement will be held every
12 months
Replace post Carbon filter T33 every 6 to 12 months.
If you do not use the system for a long time (it is vacation, travel, etc.) Please be sure to
disconnect the power supply, cutting the water supply and drain the tank.
8.4 How to change cartridges and membrane.
Prior to the change:
1.0 Unplug the equipment from the electrical outlet
1.1 Valve water supply (1)
1.2 Close the valve of the tank (14). Open faucet to release pressure
1.3 Carry out disinfection of the equipment at the same time that performs the following steps (see
point 8.5)
Change of pre and post filters
1.4 Disconnect filter from the connectors
1.5 Changing the filters and reconnect
1.6 Change T33 post-filter.
Change of membrane
1.7 Disconnect the tubing from the membrane housing head.
1.8 Unscrew membrane housing head with the key.
1.9 Remove membrane housing head.
1.10 Place the new membrane in the membrane housing
7