Installation Instructions - Depuragua RO N02T Notice D'installation Et De Maintenance

MANUAL/NOTICE DÌNSTALLATION/MANUALE DI INSTALLAZIONE

6 INSTALLATION INSTRUCTIONS

1. Preparations Check accessories (image 2)
2. Connection diagram (image 3)
3. Installation
The system was designed to fit under a sink, however, due to space limitations or other
reasons the flexible design of the system allows other places. In determining the location
remember the importance of having a line of cold water, drain, and provide easy access to the
replacement of the filters. All components and piping should be located in an area that is not
exposed to freezing temperatures. Do not expose the unit or tube to direct sunlight.
3.1. Faucet connection (image 8)
Faucet should be placed near a sink where the water is normally obtained providing ease of
use (filling jugs, water bottles and glasses), and an open area under the faucet under the sink for
the fixing of the product and the drain pipe.
Required a free space of about 5-6 cm diameter flat surface above and below the place of
installation. The thickness of the mounting surface should not exceed 5 / 4 "." The water supply to
the unit must be cold water, hot water would undermine the system.
3.2. Water supply connection (Image 9)
The water supply valve must be located as near can unity. Use only cold water inlet. (Soft)
soft water is more suitable because it will prolong the life of the Membrane.
3.3. Drain connection (image 4)
Waste should go to drain through an anti-siphon air Chamber. The air space is planned at the
base of the faucet. If poured into a sink of service or column, you must provide an air space of
more than 1 "above the flood rim. "
Do not connect the drain line close to the washing machine or dishwasher drain. The following are
instructions for downloading into the sink drain.
Place the drain pipe drain clamp above the drain trap. Leave space for the drilling. Tighten
securely. Use drill. Using port bracket as a guide, drill a hole of 7 / 32 "on the wall of the drain
pipe. " Do not penetrate the opposite side of the pipe.
Look for 1 drain tube / 4 "."
Note: Cut the tube cleanly without irregularities, failure to do so could result in a bad connection
and possible leak.
Caution: The lowest point of the line should be the point of connection with drainage clamp. There
5
(MODELS RO N02T)