Using An Ipod/Iphone/Ipad; Connecting Antennas - Teac CR-H260i Mode D'emploi

Using an iPod/iPhone/iPad

Compatible iPod/iPhone/iPad models
This unit can be connected to and used with the following
iPod/iPhone/iPad models.
iPod nano (2nd, 3rd, 4th, 5th and 6th generations)
iPod touch (1st, 2nd, 3rd and 4th generations)
iPhone 4S, iPhone 4, iPhone 3GS, iPhone 3G
iPad (3rd generation), iPad 2, iPad
p You cannot transmit the iPod/iPhone/iPad video signal
through this unit.
p To connect an iPod/iPhone/iPad to this unit's USB port,
use the USB cable provided with the iPod/iPhone/iPad.
iPod/iPhone/iPad software
If the unit or remote control buttons do not work properly
with your iPod/iPhone/iPad, updating its software might
solve the problem.
Download the latest software for your iPod/iPhone/iPad
from the following Apple website.
http://www.apple.com/downloads/
12

Connecting antennas

AM antennas
AM indoor loop antenna
To stand the loop antenna on a surface, insert the claw
into the slot in the antenna base. Connect the loop anten-
na's wires to the AM antenna terminals.
Make sure to connect the black wire to the GND terminal.
Place the antenna on a shelf or hang it on a window frame,
for example, in the direction that gives the best reception.
Keep all other wires such as power cords, speaker wires or
interconnect cables as far away from the antenna as possible.
AM outdoor antenna
In an area where AM radio signals are weak, stretch a
6–15m insulated antenna wire horizontally by a window or
outdoors, and connect it to the AM antenna connector
(not the GND terminal).
p When using an outdoor antenna, always connect a
grounding wire to the GND terminal.
p Leave the included AM loop antenna connected even
when also using a connected outdoor antenna.