Nolan N21 Sécurité Et Instructions D'utilisation page 11

4.3. Continue hooking the other fastenings one by one, moving towards the other
end of the visor (Fig. 4).
4.4. Push the trim right end against the visor to attach it to the last fastening ele-
ment (Fig. 3).
4.5. Push the trim against the visor aligning it with all the fastening elements in
order to attach it evenly along the whole visor lower edge; check that all the
fastening elements are correctly attached and that the trim and the visor fit
together tightly.
Finally, fit the visor on the helmet (see instructions above).
WARNING
- Never use the helmet without having correctly assembled the visor lower edge
trim.
- Make sure that the mechanisms are working properly. Open and close the
visor, making sure that the mechanisms hold it in the different positions and
check that the visor lower edge trim does not come out of the visor. If neces-
sary, repeat the above-mentioned steps.
- In case of malfunctioning or damages, please contact an authorised Nolan
dealer.
REMOVABLE INNER COMFORT PADDING
5. Inner Comfort Padding Disassembly
To remove the inner comfort padding, open the visor completely (see instructions
above).
5.1. Open the chin strap (see specific instructions).
5.2. Hold the left front part of the liner and pull it upwards in order to remove the
liner flap from the support fixed to the polystyrene inner shell (Fig. 7). Then
repeat the same steps for the central front and right flap
5.3. Remove the left and right sides of the comfort padding from the cavity between
the inner polystyrene shell, the outer shell and the visor side guides (Fig. 8).
5.4. Unhook the left rear flap of the liner from the support fixed to the polystyrene
inner shell by slightly pulling the comfort padding towards the inside of the hel-
met (Fig. 9). Then repeat the same steps for the central and right flap.
5.5. Remove the chin straps from the elastic loops on the straps and the from the
liner side slots (Fig. 10A).
5.6. Completely remove the liner from the helmet.
6. Inner Comfort Padding Assembly
6.1. Insert the liner correctly into the helmet and fit it well against the base
6.2. Pull the left rectangular textile extension of the liner (Fig. 10B) and insert the
chin strap into the corresponding slot in the lateral side of the liner (Fig. 10A)
then fold the rectangular textile extension of the liner inside the padding.
Follow the same steps on the right side of the helmet.
11