Connections - BLUE CHIP AXON AIX-103 Mode D'emploi

Connections

Make sure the power is OFF on all related
equipment before making any connections.
Also, set the amp volume to its lowest
setting.
1. Use the direct bass guitar signal cable to
connect the bass guitar's output jack to the
AIX-103's bass guitar input jack.
* Always connect the direct bass guitar signal cable,
even if you don't intend to use the direct bass
guitar sound. The direct signal cable is essential for
proper grounding, to minimize noise, and prevent
electric shock.
Direct Bass Guitar
Signal Cable
2. Use the 13-pin cable to connect the Guitar
13-pin Cable
AXON Rear Panel Connections
MODEL : AX 100 - SB
GUITAR TO MIDI CONVERTER
SERIAL No. : 704 101 000
to foot switch
Hold / Chain
PEDALS MIDI
IN
A X 1 0 0
HOLD CHAIN
MIDI IN
to external
MIDI tone generator .
MIDI Converter's Divided Input to the
AIX-103.
* For extra security and to prevent damage it is a
good idea to pass the cable between the strap and
Strap
13-pin Cable
bass guitar body near the body strap pin.
* The special 13-pin cable is of a locking type. To
disconnect the cable, always unlock the cable and
then remove the cable by gripping the plug firmly,
not by pulling on the cable.
2. Unplug cable by gripping
the plug firmly.
3. Connect the tone generator, bass amp, and
any other related devices to the Guitar
MIDI Converter.
4. Adjust the pickup settings on the Guitar
MIDI Converter (Refer to the AXON
manual).
5. Turn ON the power in the following order,
Tone Generator→Guitar MIDI Converter→
Related Equipment→Bass Amp
The AIX-103 power indicator should light.
With this, connection is finished and you are
ready to play.
* If the indicator does not light, double check all
connections.
MIDI MIDI
THRU OUT
BLUE CHIP MUSIC GmbH
Industriestrasse 1
56283 Halsenbach
GERMANY
Stereo Out
internal tone generator
1. Press release button.
SB-676 OUTPUT GUITAR
LEFT
ADAPTER
MONO RIGHT OUTPUT
AC -50/60 Hz
14 Volt , 1,5 A
to bass amp.
14