geo-FENNEL FIRT 1600 Data Mode D'emploi page 21

SETTING AND ACTIVATION OF THE HIGH ALARM VALUE
· Pull the trigger to power on the instrument.
· Press the MODE button until the symbol for high alarm „H" flashes in the display and ON and OFF
are shown.
· Activate (ON) or deactivate (OFF) the high alarm value by pressing the buttons UP or DOWN.
· Press the MODE button until both symbols for the high alarm value flash in the display and a tempe-
rature is shown.
H
·
· Set the high alarm value with the buttons UP and DOWN. Now a beep will sound if value set is
exceeded.
· The value set will also remain if the instrument is powered off
SETTING AND ACTIVATION OF THE LOW ALARM VALUE
· Pull the trigger to power on the instrument.
· Press the MODE button until the symbol for low alarm „L " flashes in the display and ON and OFF are
shown.
· Activate (ON) or deactivate (OFF) the low alarm value by pressing buttons UP or DOWN.
· Press the MODE button until both symbols for the low alarm value flash in the display and a tempe-
rature is indicated.
L
· Set the low alarm value with the buttons UP and DOWN. Now a beep will sound if a temperature
measured drops below the value set.
· The value set will also remain if instrument is powered off.
MEMORY
The FIRT 1600 Data can save up to 100 values. To store the values please proceed as follows:
· Pull the trigger to power on the instrument.
· Press the MODE button until one of the symbols MAX/MIN/DIF/AVG/LOG flashes in the display.
· Press the buttons UP and DOWN until LOG flashes in the display.
· Pull the trigger to confirm.
· Select a memory position from 1 to 100 with the buttons UP and DOWN (small figure on top of the
temperature indication).
· Pull the trigger to take a temperature measurement and press the button for the backlight to store
the value on the position selected.
· Select the next memory position with the buttons UP and DOWN.
· To read the values stored press the buttons UP and DOWN to select the memory position required.
See the small indication beneath the temperature displayed.
· If all memory positions are used memory positions can be overwritten.
EN
21