Important; Safety Instructions - RADSON H&C module 24V Guide Utilisateur

Installation and Operation Manual

IMPORTANT!

Before starting work the installer should carefully read this Installation &
Operation Manual, and make sure all instructions contained therein are
understood and observed.
- The thermostat should be mounted, operated and maintained by specially
trained personnel only. Personnel in the course of training are only allowed to
handle the product under the supervision of an experienced fitter. Subject to
observation of the above terms, the manufacture shall assume the liability for the
equipment as provided by legal stipulations.
- All instructions in this Installation & Operation manual should be observed when
working with the controller. Any other application shall not comply with the
regulations. The manufacturer shall not be liable in case of incompetent use of
the control. Any modifications and amendments are not allowed for safety
reasons. The maintenance may be performed by service shops approved by the
manufacturer only.
- The functionality of the controller depends on the model and equipment. This
installation leaflet is part of the product and has to be obtained.
APPLICATION
- The UFH thermostat is developed to control and manage actuators mounting on
the manifold.
- The thermostat is normally used in conjunction with a complete connecting box
"UFH-MASTER" with or without "Heating & Cooling module" to connect all
electrical & hydraulic components of the installation like a circulation pump,
actuators...
- The controllers have been designed for use in residential rooms, office spaces
and industrial facilities.
Verify that the installation complies with existing regulations before operation to
ensure proper use of the installation.

SAFETY INSTRUCTIONS

Before starting work disconnect power supply!
- All installation and wiring work related to the controller must be carried out only
when de-energized. The appliance should be connected and commissioned by
qualified personnel only. Make sure to adhere to valid safety regulations.
- The connecting boxes are neither splash- nor drip-proof. Therefore, they must
be mounted at a dry place.
- Do not interchange the connections of the sensors, actuators and the 24V
connections under any circumstances!
Interchanging these connections may result in life endangering electrical
hazards or the destruction of the appliance and the connected sensors and other
appliances.
3