Cleaning And Storage; Troubleshooting - Eurotops BC101E Mode D'emploi

Cleaning and Storage

CAUTION!
■ Danger of burns! The housing, all accessories and the charcoal in the fuel container
may also still be hot after the device is switched off. Wait until the device and the
charcoal have fully cooled down!
■ Under no circumstances should you use any corrosive or abrasive cleaning agents,
rough sponges or knives to clean the device. These could damage the surfaces.
1. Take the device apart (see the "Assembly" chapter).
2. Clean the housing (6) with a soft cloth and a little mild detergent.
3. Clean the grill rack (1) and the drip tray (5) with a little detergent under warm running
water.
4. Just tap out the tray for fuel paste (4) and the fuel container (3) as well as the lid for
the fuel container (2) and clean with a brush or a dry cloth if necessary.
Over time the heat can cause discolouration to form on the fuel container (3), the
lid for the fuel container (2) and the tray for fuel paste (4). However, this does not
restrict the performance of the device.
5. Thoroughly dry the device and the accessories before everything is reassembled and
stored away.
6. Store the device in a dry place that is protected from sunlight and is not accessible
to children and animals.

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the prob-
lem yourself.
Do not attempt to repair a defective electrical device yourself!
Problem
The charcoal does not catch
fi re.
The fan cannot be switched
on.
The grill gets too hot or there
is unwanted fl ame formation.
The grill does not get hot
enough.
03898_DE-EN-FR-NL_A5_V2.indb 17 03898_DE-EN-FR-NL_A5_V2.indb 17
17
Possible cause / solution
• Is the fan switched on? Turn the rotary knob (8) to
the MIN position or higher.
• Is the rotary knob (8) set to a position that is too
low? Turn the rotary knob (8) to the MAX position.
• Are the batteries inserted correctly? Check whether
the batteries are inserted correctly. Pay attention to
the correct polarity.
• Are the batteries empty? Replace the batteries.
• Is the rotary knob (8) set too high? Adjust the rotary
knob (8) to a lower setting.
• Is the rotary knob (8) set too low? Adjust the rotary
knob (8) to a higher setting.
EN
24.04.2017 11:35:09 24.04.2017 11:35:09