Transportation And Storage - Husqvarna 580BTS Mark III Manuel D'utilisation

1. Loosen the fasteners that holds the air filter cover in
position.
2. Remove the air filter cover (A).

Transportation and storage

WARNING:
make sure that there are no leaks or fumes
during transportation or storage. Make sure
that there is no risk of sparks or fire.
• Empty the fuel tank before transportation or long-
term storage. Push the air purge bulb to make sure
that all fuel is removed. Discard the fuel at an
applicable disposal location.
• Make sure that the product is clean and that a full
servicing is done before long-term storage.
• Remove the spark plug and put approximately 15 ml
of two-stroke oil into the cylinder. Turn the product 3
times and install the spark plug again.
• Attach the product safely to the vehicle during
transportation.
• Keep the product in a dry, cool and clean space with
good airflow. Keep the product away from children.
1667 - 002 - 19.04.2021
A
B
C
Transportation and storage
To prevent the risk of fire,
3. Remove the foam filter (B) and the paper filter (C)
from the filter frame.
4. Replace the paper filter (C).
5. Clean the foam filter (B) with warm soap water.
Note:
An air filter that is used for a long time can
not be fully cleaned. Replace the air filter regularly
and always replace a defective air filter.
6. Make sure that the foam filter (B) is dry.
7. Clean the inner surface of the air filter cover with a
brush (A).
To replace the harness
WARNING:
make the product fall and cause injuries.
1. Stop the engine.
2. Remove the clamp from the strap.
3. Push the end of the strap through the hanger.
4. Pull the new strap through the hanger.
5. Attach the clamp to the new strap.
A damaged harness can
17