Philips GC9642 Mode D'emploi page 8

ENGLISH
10
Problem Possible cause
The appliance does not There is not enough water in the
produce any steam. water tank (the 'water tank empty'
light flashes).
The appliance is not hot enough
to produce steam.
You did not press the steam
trigger.
The water tank is not placed in the
appliance properly.
The appliance is not switched on.
The appliance has The auto-off function is activated
switched off. The light automatically when the appliance
in the on/off button has not been used for more than
flashes. 10 minutes.
The appliance produces Water is pumped into the boiler
a pumping sound. inside the appliance. This is
normal.
Solution
Fill the water tank (see chapter 'Using your
appliance', section 'Filling the water tank').
Wait until the 'iron ready' light on the iron lights up
continuously.
Press the steam trigger and keep it pressed while
you iron.
Slide the water tank back into the appliance firmly
('click').
Insert the plug in the wall socket and press the on/
off button to switch on the appliance.
Press the power on/off button to switch on the
appliance again.
If the pumping sound continues nonstop, switch off
the appliance and remove the plug from the wall
socket. Contact an authorised Philips service centre.