Proper Use; Technical Data - EINHELL WW 1200 Mode D'emploi

Anleitung WW 1200 - WW 2000 SPK1
GB
3. Assembly
The appliance can be used indoors in a free standing
position or mounted on a wall. Maintain all minimum
distances. The appliance may only be used
completely assembled and standing vertically.
3.1 Free-standing installation
Observe Section 1 "Safety Instructions ".
Important! To prevent damage when attaching the
feet to the radiator, place the radiator upside down on
a soft surface (e.g. a carpet).
Slide the feet into the guides (Fig. 3) and fasten them
at the point marked (Fig. 4) with the screw provided.
3.2 Wall-mounting
Observe Section 1 "Safety Instructions ".
Do not attach the feet if the appliance is to be
mounted on the wall.
When selecting the location for the appliance,
please note that if there are skirtings on the floor
the minimum distance to the housing, or the
installation height, has to be measured from the
top of the skirting.
If the wall bracket is mounted on the back of the
radiator housing, pull it down and off (Fig. 5)
Then drill the two fastening holes with 6 mm
diameters, making sure they are horizontal, and
screw the wall bracket to the wall (Fig. 6).
Fit the radiator to the wall bracket and press it
down until the wall bracket audibly locks into
place. The radiator should now be mounted on the
wall as shown in the illustration (Fig. 7).

4. Technical data:

4.1 WW 1200
Rated voltage: 230 V ~ 50 Hz
Output: 1200 W (500 W/ 700 W/ 1200 W)
Thermostat control: Infinitely adjustable
Protection class:
Protection type:
Mains lead: 3 x 1 mm
Appliance dimensions without feet approx.:
59 x 7.5 x 45 cm
8
26.04.2006 10:42 Uhr
4.2 WW 2000
Rated voltage:
Output: 2000 W (1000 W / 2000 W)
Thermostat control:
Protection class:
Protection type:
Mains lead:
Appliance dimensions without feet approx.:

5. Proper use

The appliance is designed only for private use, not
for commercial heating purposes.
6. Starting up
Important! Before using the appliance for the first
time, check that the voltage supply is the same as
the voltage details set out on the rating plate.
Read the safety instructions listed in section 1.
When the heater is used for the first time or after a
long period of rest it may emit an odor for a short
time. This is not a fault.
If the appliance should topple or fall over, the
power supply will be cut off by an integrated safety
switch in the appliance. The power supply
resumes as soon as the appliance is stood upright
again.
6.1 WW 1200 switch for heat output
(Fig. 1/ Item 2)
Low heat output (500 W): 500 W heat setting LED
lights up in heating mode
Medium heat output (700 W): 700 W heat setting
LED lights up in heating mode
Maximum heat output (1200 W): 1200 W heat
setting LED lights up in heating mode
6.2 WW 2000 switch for heat output
(Fig. 2 / Item 2)
Low heat output (1000 W): 1000 W heat setting
LED lights up in heating mode
Maximum heat output (2000 W): 2000 W heat
I
setting LED lights up in heating mode
IP24
2 x 1.8 m
6.3 Thermostat control (Fig. 1 / Item 3):
Switch on the desired heat output with the heat
output switch. Turn the control to "HI" until the
required room temperature is reached. The
Seite 8
230 V ~ 50 Hz
Infinitely adjustable
I
IP24
3 x 1 mm 2 x 1.8 m
69 x 7.5 x 45 cm