Associate The Camera To The Receiver; Viewing The Camera Or The Cameras - Extel WESV 82600 Guide D'installation Et D'utilisation

c. Associate the camera to the receiver
For the first use, the camera included in the kit is already paired. If not or to add another
camera, proceed as follows:
Press the key "M" of the receiver and go to the "PAIR CAM" menu with the key q.
Select a free channel between 1, 2, 3 and 4 with the keys t and u .
Press the key to start registering.
You have 60 seconds to pair the camera.
Open the cover located at the back of the camera and then press the button "Pairing key"
with a sharp object (for example a paper clip).
Only one channel per camera can be activated on the receiver.
In the case of several cameras, you should choose 1 different channel for each camera.
d. Viewing the camera or the cameras
To view one or several cameras (if you have installed additional cameras), use the key
Caution, in the case of several cameras, you should make sure that they are parameterized
in view in the menu.
To do so, press the key "M" of the receiver, and make sure that the channels of the registered
cameras are set on "ON" Example: "CAM1 ON"
To modify it, select the channel with the key q and modify the state with the keys tand u.
The cameras in "OFF" position will not be visible during manual or automatic scrolling.
The number in the left upper corner of the screen indicates the selected camera.
Audio Vol
Scan Time
Camera 1
Camera 2
Camera 3
Camera 4
Pair CAM
Reset
10
OFF
ON
ON
ON
ON
1 2 3 4
CFI EXTEL WESV 82600 - 06/2009 - V1
.
11GB