Location And Function Of Parts And Controls; Front Panel - Sony Trinitron PGM-200R1A Mode D'emploi

Location and Function of Parts and Controls

Front Panel

1 POWER switch
ON OFF
2 STAND BY indicator
STAND BY
3 Remote sensor
4 CONTROL button
CONTROL
+
5 VOLUME +/– buttons
VOLUME
–
6 POWER (RGB1) indicator
RGB1
7 MENU button
MENU
+
8 SELECT +/– buttons
SELECT
–
9 ENTER button
ENTER
4 4
(EN)
1 POWER switch
Press to turn the monitor on. Press again to turn it off.
2 STAND BY indicator
Lights up when the monitor is turned off with the
Remote Commander.
3 Remote sensor
Receives the beam from the Remote Commander.
4 CONTROL button
To operate the buttons on the front panel, first press
this button. Then the buttons light up that shows they
can be operated. Press again to deactivate them.
5 VOLUME +/– buttons
Press to obtain the desired volume.
6 POWER (RGB1) indicator
Lights up when the monitor is turned on.
7 MENU button
Press to make the menu appear or to go to the
following menu.
8 SELECT +/– buttons
Press to move the cursor (z) to an item or to adjust
value in a menu.
9 ENTER button
Press to select the desired item in a menu.
Notes
• If the picture disappears suddenly and the STANDBY
indicator flashes, there may be a failure in the
monitor. Unplug the unit and call your authorized
Sony dealer.
• There is the DIN 8-pin connector under the cover on
the lower-left corner of the front panel.
This connector is only for qualified personnel.
Do not remove the cover and the screw.