Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch GLI 12V-330 Professional Notice Originale

OBJ_BUCH-2909-001.book Page 20 Tuesday, July 19, 2016 2:15 PM
20 | English

Working Advice

The cordless worklight runs at reduced brightness when the battery capacity is at ap-
prox. 1.3 %. The cordless worklight flashes 3 times before the brightness decreases.
Swivelling the Lamp Head (see figure A)
The lamp head 1 can be swivelled up to 200° to suit the application.
– As an uplight with the lamp head aimed upwards.
– Swivelled 90° to shine light into the room.
– With lamp head tilted approx. 120° for glare-free lighting of the work area, e. g. a
desk.
– With lamp head tilted approx. 200° to illuminate the floor.
Note: At a tilt of more than 90° the cordless worklight has to be fixed.
Utility Hook (see figure B)
You can use the utility hook 7 to attach the cordless worklight to an object.
Carabiner (see figure C)
You can use the carabiner 4 to attach the cordless worklight e. g. to a rope or belt.
Magnetic Mount (see figure D)
You can use the magnetic mount 6 to attach the cordless worklight to ferromagnetic
surfaces. Do so carefully in order to avoid scratching delicate surfaces.
Tripod Mount (1/4") (see figure E)
You can use the tripod mount 8 to screw the cordless worklight onto a tripod.

Maintenance and Service

Maintenance and Cleaning

When the battery is no longer operative, please refer to an authorised after-sales ser-
vice agent for Bosch power tools.
The cordless worklight is maintenance-free and contains no components that must be
replaced or maintained.
 The light source cannot be replaced. If the light source is defective, the entire
cordless worklight has to be replaced.
To avoid damage, clean the plastic lens of the cordless worklight only with a dry, soft
cloth. Do not use cleaning agents or solvent.
1 609 92A 2MM | (19.7.16) Bosch Power Tools