Ferroli SKY ECO F 7 Instructions D'utilisation, D'installation Et D'entretien page 81

SKY ECO F
• In case of doubt, do not use the unit.
Contact the supplier.
• The unit and its accessories must be
appropriately disposed of in complian-
ce with current regulations.
This symbol means "Caution," and is displayed next to safety war-
nings. Carefully observe such warnings to avoid hazardous situa-
tions, property damage, and injury to people and animals.
Important information involving no risk of injury or property damage is indicated by this symbol.
The CE marking certifies that products meet the fundamental requirements of the applicable
European directives.
The declaration of conformity can be requested from the manufacturer.
1 USER'S MANUAL ................................................. 81
1.1 Introduction ......................................................... 81
1.2 Control panel ...................................................... 82
1.3 Turning the unit on and off .................................. 82
1.4 Adjusting the DHW . ............................................. 82
2 INSTALLATION MANUAL..................................... 83
2.1 General information ............................................ 83
2.2 Location .............................................................. 83
2.3 Assembling the heater ........................................ 83
2.4 Hydraulic connections . ........................................ 84
2.5 Gas connection . .................................................. 85
2.6 Electrical connections ......................................... 85
2.7 Air and flue gas ducts ......................................... 86
1 USER'S MANUAL
1.1 Introduction
The new SKY ECO F is an instantaneous, high-performance, low-emission heater for domestic hot water production,
powered by natural gas, LPG or propane-air and equipped with a compact, WATER-COOLED burner, electronic
ignition, sealed chamber, MODULATING fan, and control system with microprocessor.
• The images given in this manual are
a simplified representation of the pro-
duct. In this representation there may
be slight and insignificant differences
with respect to the product supplied.
3 SERVICE AND MAINTENANCE ........................... 88
3.1 Adjustments ........................................................ 88
3.2 COMMISSIONING . ............................................. 90
3.3 MAINTENANCE . ................................................. 91
3.4 FAULTS . .............................................................. 91
3.5 Parameters ......................................................... 93
4 TECHNICAL DATA AND CHARACTERISTICS .... 94
4.1 Dimensions and connections . ............................. 94
4.2 Overview and main components ........................ 95
4.3 Hydraulic circuit .................................................. 95
4.4 Technical data table ............................................ 96
4.5 Wiring diagram . ................................................... 98
cod. 3541S170 - Rev. 04 - 09/2019
81
EN