FarmaMed BLUETOOTH SMART Instructions D'utilisation page 17

PREPARING THE SCALE
1) INSERT BATTERIES
This scale works with three AAA 1.5V replaceable alkaline batteries (not
included)
• To insert the batteries open the battery compartment by pulling the cover tab.
• Insert the batteries observing the indicated polarity. Close the cover.
• Place the scale on a flat and solid surface. A solid horizontal surface is conducive
to correct measurements.
• When the battery is low a message is displayed on the screen.
2) SELECT THE UNIT OF MESUREMENT
The scale is set to kg when first switched on.
If the units are other than kg when first switched on, or to select a different unit
of measurement at any time (lb or st), press "UNIT" on the back of the appliance
(Fig. 3), until the desired unit of measurement appears.
3) PLACE THE SCALE CORRECTLY
Place the scale on a flat and rigid surface. If the floor is uneven or not solid (e.g.
carpet, rug, linoleum), the reliability of the measurement may be impaired.
INSTRUCTIONS FOR USE
1) BODY WEIGHT MEASUREMENT
• Step on the scale with scale switched off, your feet parallel and correctly placed
on the electrodes and your weight evenly distributed on the platform. Wait for
the scale to compute your weight without moving. Do not lean onto anything
during the measurement to prevent altering the readings.
• Step off the scale, your weight keeps being displayed for few seconds, then the
scale switches off automatically.
The body composition data are displayed on the smartphone only with the
"FitGo" App.
By using the scale in offline mode it is however possible to measure your weight,
by following the steps below.
2) OPERATION WITH APP
List of compatible devices:
iOS from version 7.0, Android™ from
version 4.3 with Bluetooth® 4.0.
Installing the App and Registration
• Switch on Bluetooth® in the device settings.
• Scan the QR code or download the free "FitGo" App
from App Store™ or from Google Play Store™.
• Follow the App's instructions to set up a new user with your personal
information.
• Step on the platform with scale off, taking care to properly place your bare feet
on the two electrodes.
• The scale displays the weight and the symbol indicating that the scale and
device connection is active.
• At this stage, your device displays and stores the following data.
iOS App Android App
23 17
EN EN