EINHELL BMS 1000 Mode D'emploi page 7

Anleitung BMS 1000
Drilling bit stop
Caution:
For safety reasons always use the
additional grip when working. As the
noise level exceeds 58 dB (A)
during operation it is recommended
to wear an ear protection.
08.11.2001 13:54 Uhr
Hammer drill
Drilling/screwing
On/off switch
Switching Press operating
on: switch A
Continuous: Secure switch A
operation: with lock button B
Switching Press operating switch
off: A for short period.
Select the correct speed for any type
of work (for example, driving screws,
drilling, etc.) by firmly pressing on the
operating switch (A).
Seite 7
Caution:
The bits should be tightened on
all three holes in the chuck.
After tightening remove the key
for the chuck.
Caution:
Only switch at standstill. When
drilling in tiles and stove tiles
set to position drill/screw.
Clockwise rotation Anti-clockwise operation
Turning the speed control to the right
increases the revolution
Position 2
Caution:
Only switch over from position 1 to
position 2 when machin e is not
running.
GB
7