Bosch Home Professional BSG8PRO1 Notice D'utilisation page 19

en
Changing the micro-hygiene filter*
The micro-hygiene filter should be replaced
with every new replacement filter pack (after
5 dust bags) and at least once a year.
18
Figure
Press the locking tab in the direction of the
arrow to unlatch the exhaust grille and
open it.
Unlatch and remove the filter frame by
pressing the tab in the direction of the
arrow.
19*
Figure
Remove the foam and micro-hygiene filter.
Dispose of the micro-hygiene filter and fit a
new micro-hygiene filter.
Clean the foam and replace in the filter
frame.
If you have used the vacuum cleaner for fine
dust particles (such as plaster or cement),
clean the motor protection filter by tapping it
and, if necessary, replace the motor protection
filter and the micro-hygiene filter.
20
Figure
Slide the filter frame under the two retaining
ribs and push in the direction of the arrow
until it engages.
Close the exhaust grille.
Replacing the Hepa filter*
If your vacuum cleaner is fitted with a HEPA filter,
this must be replaced once a year. (See figures
18 and 20 for changing the filter)
* Dependent on model
14
Replacing the active carbon filter*
If your vacuum cleaner is fitted with an active
carbon filter, this must be replaced once a year.
21*
Figure
Remove the active carbon filter and dis-
pose of it with the household rubbish.
Insert a new active carbon filter. (See
Figures 18-20 for changing the filters)
Care
Always switch off the vacuum cleaner and dis-
connect the power cord from the mains before
cleaning the appliance.
The vacuum cleaner and plastic accessories can
be cleaned with a commercial plastic cleaner.
!
Do not use a scourer, glass-cleaning
agent or all-purpose cleaning product.
Never immerse the vacuum cleaner in
water.
The dust compartment can, if necessary, be
cleaned with a second vacuum cleaner or sim-
ply wiped with a dry cloth or dusting brush.
Subject to technical modifications.