Kärcher FLEX VC 35 L MC Mode D'emploi page 16

on account of increased release of fine dust
particles.
Anti-static system
Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks with attachments with electrical
conductivity included in the delivery.
Dry vacuum cleaning
The appliance is equipped with a fleece
–
bag with a locking slide, order no.
329.630 (5 pc).
Note:You can use this appliance to vacu-
um all types of dust up to dust class L. It is
statutorily necessary to use a dust collec-
tion bag (see Filter systems for order
number).
Note:The appliance is suited as industrial
vacuum cleaner and as dedusting device
for the mobile operation to take up dry, non-
combustible dusts with MAK values greater
than or equal to 1 mg/m
Caution
The flat pleated filter must must always be
in place while vacuuming.
To vacuum fine dust, you must use an
–
additional fleece filter bag.
Install fleece filter bag
Illustration
 Release and remove the suction head.
 Insert the fleece filter bag.
 Insert and lock the suction head.
Wet vacuum cleaning
Warning
No dusts hazardous to health should be
sucked in during wet vacuuming.
Inserting the rubber lips
Illustration
 Remove the brush strips.
 Install the rubber lips.
Note: The structured side of the rubber lips
must point outwards.
Remove the fleece filter bag
Illustration
16
.
3
EN
 Release and remove the suction head.
 Pull the fleece filter bag towards the
rear.
 Pull the locking slide up and seal the
fleece filter bag tightly when removing it.
 Dispose of the fleece filter bag accord-
ing to the local provisions.
 Insert and lock the suction head.
To suck wet dirt, first remove the fleece
–
filter bag.
General
Caution
The flat pleated filter must must always be
in place while vacuuming.
If wet dirt is vacuumed with the uphol-
–
stery or crevice nozzle or if water is
sucked up from a container it is recom-
mended to deactivate the "Filter
Dedusting" function.
If the maximum liquid level is reached
–
the appliance will turn off automatically.
In case of non-conductive liquids
–
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
After the wet vacuuming: Clean the flat
–
folded filter with the filter cleaning.
Clean the electrodes with a brush.
Clean the container with a damp rag
and dry it.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
3
-